When ScanSnap iX1300 cannot establish a connection to a wireless access point, the ScanSnap can connect directly to the computer via Wi-Fi.
[Procedure]
*This function is only available for computers that have a Wi-Fi function.
*If iX1300 is turned on, close the ADF paper chute (cover) to turn it off.
*When iX1300 is connected to a computer via a USB cable, disconnect the USB cable from the computer.
- Open the cover while holding down the WPS button on the back of iX1300.
- Release the WPS button when the Wi-Fi indicator blinks in green.
Confirm that the Wi-Fi indicator lights up in orange.
- Open the window for setting the network (Wi-Fi) function on the computer.
For details, refer to the manual of the computer.
- In the window for setting the network (Wi-Fi) function, select the "SER.NO". for iX1300.
If you are asked to enter a security key, enter the "SECURITY KEY" for iX1300.
*The "SER.NO." and "SECURITY KEY" can be found on the label attached to the bottom of iX1300.
- The computer and the ScanSnap are connected directly.
Confirm that the Wi-Fi indicator on iX1300 lights up in green.
- Load documents on the ADF paper chute (cover), then press the [Scan] button to try scanning.